欢迎访问过程工程学报, 今天是

过程工程学报 ›› 2021, Vol. 21 ›› Issue (5): 550-557.DOI: 10.12034/j.issn.1009-606X.220393

• 流动与传递 • 上一篇    下一篇

高雷诺数下变截面分流歧管面积比对流体分配性能的影响

杨宏刚1,2， 王 楠1， 王 怡2,3*， 姚 蕾1， 采晓帆2,3   

  1. 1. 西安建筑科技大学资源工程学院，陕西 西安 710055 2. 西安建筑科技大学西部绿色建筑国家重点实验室，陕西 西安 710055 3. 西安建筑科技大学建筑设备与工程学院，陕西 西安 710055
  • 收稿日期:2020-12-03 修回日期:2021-02-17 出版日期:2021-05-22 发布日期:2021-06-01
  • 通讯作者: 王怡 wangyi6920@126.com
  • 基金资助:
    国家重点研发计划;西安建筑科技大学人才科技基金

Effect of area ratio of variable cross-section dividing manifolds on performance of fluid distribution in high Reynolds number

Honggang YANG1,2, Nan WANG1, Yi WANG2,3*, Lei YAO1, Xiaofan CAI2,3   

  1. 1. School of Resources Engineering, Xi'an University of Architecture and Technology, Xi'an, Shaanxi 710055, China 2. State Key Laboratory of Green Building in Western China, Xi'an University of Architecture and Technology, Xi'an, Shaanxi 710055, China 3. School of Building Services Science and Engineering, Xi'an University of Architecture and Technology, Xi'an, Shaanxi 710055, China
  • Received:2020-12-03 Revised:2021-02-17 Online:2021-05-22 Published:2021-06-01

PDF

摘要： 在高雷诺数(Re=5×105~30×105)下，对不同主管形状和面积比的分流歧管流体分配性能进行数值模拟。通过计算各支管出流流量比(Q/Qave)与流量分配均匀性指数(U)，分析Re和主管形状以及面积比(AR)对分流歧管流量分配性能的影响。结果表明，与低Re下的分流歧管流量分配性能高度依赖于Re的规律不同，高Re(5×105~30×105)下分流歧管的流量分配性能几乎不受Re的影响；在相同Re与AR下，主管形状为三角形渐缩的分流歧管的流量分配性能优于其他两种主管形状；随AR增加U总体呈下降的趋势，当AR?1.0时，随AR增大，三种主管形状的分流歧管流量分配均匀性均显著下降，当AR=0.8~1.0时，分流歧管的流量分配均匀性指数变化不明显。

关键词: 分流歧管, 雷诺数, 主管形状, 面积比, 均匀性指数

Abstract: As a fluid distribution device, the dividing manifold is widely used in engineering systems such as air supply ducts, heat exchangers, and large bag filters. The flow distribution uniformity of the dividing manifold directly affects the overall performance of the system. A geometric model of dividing manifold was proposed to prevent dust accumulating with consideration of the problem of preventing dust and particles from accumulating in dust-containing airflow in practical engineering. With the aim of providing theoretical guidance and basis for the design of shunt manifold, the numerical simulation study on the fluid distribution performance of dividing manifolds with different main pipe shapes and area ratios was carried out to obtain the optimal flow distribution uniformity of the dividing manifold. The effects of Re, main pipe shape and area ratio (AR) on the flow distribution performance of the dividing manifold were analyzed. The results showed that at high Reynolds number, the flow distribution uniformity of dividing manifold was hardly affected by the inlet Reynolds number. When the inlet Reynolds number and area ratio remained unchanged, the flow distribution uniformity of the manifold with a triangular main pipe shape was obviously better than that of the other two main pipe shapes. As the increase of area ratio of the dividing manifold, the flow distribution uniformity index U of the dividing manifold generally decreased. When the area ratio was greater than 1.0, the flow distribution uniformity of all dividing manifolds was decreased. When the area ratio was between 0.8 and 1.0, the flow distribution uniformity index of dividing manifold did not change significantly.

Key words: dividing manifold, Reynolds number, main pipe shape, area ratio (AR), uniformity index